Selenoid Valve

Bosch-Rexroth has also provided us with a single solenoid valve. The fittings allow you to push on the tubing and then tighten down on the tubing with the nut. The pressure port is shown on the top of the valve 6 and marked “P”. Flow comes out the “B” port and switches to the “A” port when the coil is energized. A solenoid connector plug is provided to wire the solenoid. The yellow arm on the opposite side of the valve is the manual override. On this valve you can turn the override on and leave it in that position for testing. Note there is no nut on the “R” port, which is the exhaust port. Please remove the Black nuts which are for metric tubing and use the Gray nuts which are included. If you lose a gray nut, drill ¼” hole in one of the black nuts to use instead.